Installed a Noctua NF-R8 1200rpm fan in the PSU. This one's almost inaudible but seems to push a reasonable amount of air.
![pg3PR6Rl.jpg](http://i.imgur.com/pg3PR6Rl.jpg)
Also fit the Gotek and managed to get it hooked up using the original floppy cable & 3.5 drive. The Tandy has 5V on pins 3,5,9 & 11 and 12V on 29,31 & 33, so it's necessary to cut those when connecting a non-Tandy drive otherwise you'll get a short circuit 😵
The Gotek seems to be working fine, I was able to boot from it and play Prince of Persia. My disk image selector doesn't work though so some debugging needed there.
![BfPHyKRl.jpg](http://i.imgur.com/BfPHyKRl.jpg)
![st7Qc5Dl.jpg](http://i.imgur.com/st7Qc5Dl.jpg)
Also fixed the power switch on my Tandy TTL monitor so we're getting towards a complete system. The keyboard should be over the Atlantic about now. Next steps will be to get the XT-IDE and DOM working.