First post, by mperelman
When I am changing an existing file, and put the old file on my C drive. My computer was just replaced and DOSBOX does not recognize the C Dr. except right after I mount the drive. When using my outliner, Maxthink, the program does not recognize the C Dr.
I can close the program, which leaves me with the command prompt, which does recognize the C drive.
I have not had a problem like this in my older backup computers.
Thank you
Michael
Michael Perelman
Economics Department
California State University
Chico, CA
95929
530 898 5321
fax 530 898 5901
http://michaelperelman.wordpress.com