First post, by fsmith2003
- Rank
- Member
Just curious if anyone can help me out and let me know what steps I may be missing. I have a fully assembled XT-IDE 8-Bit ISA revision 3 card for my Tandy TL/2. I run setupltl2 /a to have it boot from disk instead of from rom. The Xtide bios does show up and also shows my IDE Drive I have connected to it as Master. However when I run fdisk from my Tandy Setup floppy disk it says that there is already a "non-dos" partition on the Hard Drive and will not let me install the dos partition. I am unable to access any portion of the hard drive without using fdisk on it first so I am kind of stuck at the moment. Is anyone on here familiar with this device and what I may need to do to get this to work?