First post, by dreamblaster
I designed new PCB : OPL2LPT , or nickname 'ADLIPT 1' :
A compact 'adlib' on parallel port, 3.5mm line out connector.
PCB's and components ordered for the first few prototypes,
these should be ready around 2nd week of august.
This time I took care to make it 'all through hole', so it can be a solder kit.
This was inspired by this project : http://www.raphnet.net/electronique/adlib/adlib_en.php
I used the same parallel port pinout mapping, so his adplug modification should work.
Any other software that could work ?
For DOS machines, the ultimate would be a small DOS TSR that captures 0x388 and 0x389 writes and outputs on the parallel port instead.
---- ---- ---- ----
EDIT 2020 :
Here is the related software : https://github.com/pdewacht/adlipt/releases
Here are programming examples :
For OPL2LPT: https://github.com/pdewacht/adlipt/issues/1#i … mment-352285382
For OPL3LPT: https://github.com/pdewacht/adlipt/issues/1#i … mment-403243022