Hi everyone, first post here on this forum. Trying to re-build the old family i486 DX2 computer and I was wondering if the Gigabyte GA486AM/S is compatible with EDO RAM. I don't see any mention of EDO in the motherboard's manual, any clue on this ?
If you've got EDO sticks, try them, they run FPM if not supported. If you're wanting to buy some, when you've already got FPM for it, wait for answer, if you've got no sticks for it, and EDO will cost you same as FPM then again, may as well try them.
Edit: Gut feeling is it does, pretty much every board with PCI, and every board with low voltage support seemed to support.
Unicorn herding operations are proceeding, but all the totes of hens teeth and barrels of rocking horse poop give them plenty of hiding spots.
Ok, it seems that it's a die and retry procedure so I just bought both. Thanks for your answer I will keep you informed.
Hi, the UM8881F memory controller chip has a 3 letter combination right after the date code (eg. 9520-EXX), letter E indicates EDO support.
Thanks for the update SSTV2, I tested it and I can tell you that it definitely doesn't support EDO RAM. For the record the UM8881F memory controller date code was 9544-BTA.
Mine also doesn't accept EDO Ram. It's also a BTA-Revision chipset
