Reply 20 of 45, by Roman555
Nemo1985 wrote on 2021-08-07, 09:04:Thank you for the tips. […]
Thank you for the tips.
Typo fixed, I checked the voltage it is: v1.883, so I guess it is ok...
The board boots less and less, during last try it booted just once and it did after some time it was turned on, I was busy pushing chips and it suddenly started.
Anything gets hot, cpu, nb and southbridge if it matters.
That's a picture of the board, if you need any detailed picture or anything I should measure, that's something i'm able to do 😀
s-l1600.jpg
You're welcome.
This model has three typical problem : s478 (loose solder balls), the northbridge (loose solder balls or bad chip) and APM3055.
Loose contacts may be found if the CPU and/or NB is pressed before turn on. APM3055 are better to be replaced for something reliable.
Anything else demands proper diagnostic at a workshop.
[ MS6168/PII-350/YMF754/98SE ]
[ 775i65G/E5500/9800Pro/Vortex2/ME ]