First post, by Babasha
- Rank
- Oldbie
Nice find in my warehouse…
Same tablet WITH stylus pen was my first graphics tablet. This one with cross-mouse for CAD.
Lets do it next monday? 😉
Need help? Begin with photo and model of your hardware 😉
Nice find in my warehouse…
Same tablet WITH stylus pen was my first graphics tablet. This one with cross-mouse for CAD.
Lets do it next monday? 😉
Need help? Begin with photo and model of your hardware 😉
Tablet is new in working condition.
Drivers for DOS, Win3.x, Win9.x, WinNT and AutoCAD 12 and power supply photo attached.
Supported Models:
- DrawingBoard (23xxx models manufactured after Aug, 1988)
- 2500 (25xxx models)
- DrawingSlate (31xxx models)
- DrawingSlate II (32xxx models)
- DrawingBoard II (33xxx models)
- DrawingBoard III (34xxx models)
- EstiMat/DrawingFlex (33364 and 33484 models)
- 9100 (91xxx models with Rev F or later firmware)
- 9500 (95xxx models)
- Wiz (33110-11 model)
- NotePad (33111 model)
Need help? Begin with photo and model of your hardware 😉
That is beautiful 😀 Nice work uploading the disk contents too. Hopefully in a week or so, I will be receiving one myself for a retro CAD setup. I don't know much about it yet, except that it's boxed and it's probably a Kurta.