First post, by amontre
- Rank
- Newbie
My CRT front face panel are not working and i cant adjust the geometry and Im too scared to open the monitor. It’s a 486 machine with built in Wingine DCX onboard display.
As you can see, its too squashed i cannot use the panel to adjust.
However i tried using a utility from Trident VGA called TVGACRTC.exe which can adjust the geometry by Software. Since This computer are not using Trident card it doesnt save the settings.
Is there other monitor utility i could use to adjust the geometry and probably load it in config.sys ?
NEC Pentium 133 | 96mb RAM | 40gb HDD | s3 Virge DX | Voodoo 2 | SB AWE64 Gold | Roland MT-32 & SC 55MkII