First post, by TheLazy1
My attempt to get a Tualeron working in my P3V4X has failed so I'm trying to track down why.
Half of the mod was done cpu side with pin removal, and the AK4->AN11 bridge was done on the back of the slocket.
On bootup all it did was give the OH GOD THE CPU IS BAD error so something is awry.
Popping in a Coppermine gave the same error until I snipped the bridge, but it still wouldn't boot up until I set the slocket voltage manually.
Oddly enough after it boot with 1.65v set on the slocket it still ignores the FSB selection and just goes by what the BIOS wants.
Can anyone take pictures of their completed mods?
There are only a few low-res ones around.
Alternately, any thoughts why this might be failing?