FIC-486-VIP-IO VRM components \ VOGONS

FIC-486-VIP-IO VRM components

Topic actions

First post, by DAVE86

Posted on 2015-12-09, 09:30

DAVE86 Offline

Rank Member

Rank: Member
Posts: 128
Joined: 2015-12-08, 21:22
Location: Hungary

Hi!

My FIC-486-VIP-IO is missing the VRM module. Placing the parts should not be a problem. I already prepared the vias for the through hole compnents. All I need is the resitor values on positions R86, R87, R89, R92, R93, R113. Luckily the active components part numbers are silkscreened on the board. If someone could list the values or post a high resolution picture of that area I would appreciate it!

The attachment ficvipiovrm.jpg is no longer available

Thanks!
David

Reply 1 of 3, by DAVE86

Posted on 2015-12-10, 21:08

DAVE86 Offline

Rank Member

Rank: Member
Posts: 128
Joined: 2015-12-08, 21:22
Location: Hungary

I sort of managed to figure out the values, but it would hurt to make sure 😊 I'm still selecting the right coil also.

Reply 2 of 3, by kanecvr

Posted on 2015-12-10, 22:51

kanecvr Offline

Rank Oldbie

Rank: Oldbie
Posts: 1957
Joined: 2015-04-22, 20:30
Location: Bucharest, Romania

I have two 486-vip-io but not on hand (they are in storage). Unfortunately the only pictures of the VRM area I have are quite blurry so they will be no help. PM brostein or hightreason. One of them should be able to help.

Reply 3 of 3, by DAVE86

Posted on 2015-12-11, 11:15

DAVE86 Offline

Rank Member

Rank: Member
Posts: 128
Joined: 2015-12-08, 21:22
Location: Hungary

Thanks for the hint! It's going to be sorted out after all. Brostenen will take some pictures of his board.

Go to top of page Go to top of page

Back to General Old Hardware