VOGONS


First post, by mzry

User metadata
Rank Member
Rank
Member

Heya,

On one of my P2 systems I had to bend all of the PCI brackets for them to slot in properly because the mobo was too low down. On a P3 mobo in the same case the PCI slots don't need any adjusting. Is this normal?

Thx

Reply 1 of 5, by brassicGamer

User metadata
Rank Oldbie
Rank
Oldbie

Hmm... would this depend on the case you're using and the size of the stand-offs you're using?

Check out my blog and YouTube channel for thoughts, articles, system profiles, and tips.

Reply 3 of 5, by kaputnik

User metadata
Rank Oldbie
Rank
Oldbie
brassicGamer wrote:

Hmm... would this depend on the case you're using and the size of the stand-offs you're using?

Mm. Can also imagine newer boards might have more layers, and the laminate generally become somewhat thicker.

Perhaps it could be offset with washers between the standoffs and the board?

Reply 4 of 5, by Errius

User metadata
Rank l33t
Rank
l33t

No these things aren't standardized, and different cases use different height stand-offs. Why wouldn't this be defined in the ATX standard?

Is this too much voodoo?

Reply 5 of 5, by mzry

User metadata
Rank Member
Rank
Member

Thanks for the replies, I'll see if I can get taller stand offs.