Thak you for this tool!
I itested it in a PCChips / Elpina M919 v3.4 board with an "It's ST 486DX100" CPU, without L2 cache module. The CPU model detected in HWiNFO is a Cyrix with 4Kb L1 cache, but in fact this ST CPU has 8Kb.
And about 70% of the time when I exit the tool, the computer hangs with HDD led lit all the time. Some others, it does not hang at exit time but when I try to access some files or dirs in the HDD later, I see corruptions or hangs.
EDIT: Now I tested with 6.0.2 (Previously I did with 6.0.0) and now the L1 cache size reported vary from execution to execution... sometimes it whows 8Kb, sometimes 4Kb. The CPU is recognized exactly as: "Cyrix FasCache Cx486DX4-v, 100.0 MHz". Other issues remain the same. Oh, and I tried to run it with the full report switch (/R) but the computer hangs in "Peripherals Information" section, and I can see in the left corner a "Divide error" text. Few minutes later, an HDD read error appears, like "Not ready writing drive C".
Thanks.