This Tandy Enhanced Keyboard found on local internet auction.
Beside the slightly stretched cable it looks almost like new - basically it's in perfect condition because probably it was used wrapped in it's rubber cover since it was new.
Nobody else was bidding on it. I guess people just didn't knew it's almost as good as Model M, has XT/AT mode autodetect...

Will be perfect for my 1000TL/2.

Cool keyboard.

Finally found a P4EE that didn’t cost an arm and a leg:

Came on an MSI 865 board with 2GB RAM. Will now have to find a suitable case for this setup.

JidaiGeki wrote on 2021-08-18, 03:00:

Finally found a P4EE that didn’t cost an arm and a leg:

Yeah, that's funny, the cheap ones usually have Xeon stamped on them. 😉

Pentium 100 mhz machine for 10 bucks
Toshiba sattelite 420ct

Works, but dies out if you start any app because the fan in the back isnt working.

Also got this for 10 bucks

P2 IBM 390
Everything seems to work well on it.

A couple of nice bargains there!

I received a NOS ASUS Socket 8 to Slot 1 adapter last week. It came with a BIOS chip and a BIOS update floppy.

bjwil1991 wrote on 2021-08-17, 02:40:

I have a T2150CDT myself. Remove the wake battery (open the hood, remove the main battery, move the plastic anti-static piece, r […]
Show full quote

SteveC wrote on 2021-08-16, 19:27:

Also picked this up on eBay today for very little money - the screen has stopped working so might be fun to fix. (Seller's photos)

Toshiba Satellite T2150CDS 75MHz intel 486DX, CD drive Windows 95

I have a T2150CDT myself. Remove the wake battery (open the hood, remove the main battery, move the plastic anti-static piece, remove the 4-5 screws, and remove the 7.2V NiMH battery and clean the corrosion off before it's too late.

If you need the drivers and utilities, I'll send a link to all of it.

Oh. Before I forget, a floppy drive from a Satellite Pro 400 Series will work with it as well (tested myself since the original broke on me).

So it turned up today and I checked where you said and there's just a coin cell rechargeable battery with no leakage?

The machine worked fine for about 15-20 mins - I got into Windows 95, even played some games, (even the battery worked for about 10 mins!) but I had a few random crashes then tried copying over some files from a CD and it froze and now I can hardly get it to boot at all- it just hangs on a bare DOS prompt even. Sometimes I've even had this screen saying the BIOS is damaged come up on a couple of boots! (Sorry for poor quality picture).

Are these easy to take apart? Is there a heatsink on the CPU or something that might need new paste? Is there a fan that's failed even? I'm going to leave it for a bit and try again later.

Cheers,
Steve

SteveC wrote on 2021-08-18, 21:54:

So it turned up today and I checked where you said and there's just a coin cell rechargeable battery with no leakage? 20210818_2 […]
Show full quote

bjwil1991 wrote on 2021-08-17, 02:40:

I have a T2150CDT myself. Remove the wake battery (open the hood, remove the main battery, move the plastic anti-static piece, r […]
Show full quote

SteveC wrote on 2021-08-16, 19:27:

Also picked this up on eBay today for very little money - the screen has stopped working so might be fun to fix. (Seller's photos)

Toshiba Satellite T2150CDS 75MHz intel 486DX, CD drive Windows 95

I have a T2150CDT myself. Remove the wake battery (open the hood, remove the main battery, move the plastic anti-static piece, remove the 4-5 screws, and remove the 7.2V NiMH battery and clean the corrosion off before it's too late.

If you need the drivers and utilities, I'll send a link to all of it.

Oh. Before I forget, a floppy drive from a Satellite Pro 400 Series will work with it as well (tested myself since the original broke on me).

So it turned up today and I checked where you said and there's just a coin cell rechargeable battery with no leakage?
20210818_221955.jpg

The machine worked fine for about 15-20 mins - I got into Windows 95, even played some games, (even the battery worked for about 10 mins!) but I had a few random crashes then tried copying over some files from a CD and it froze and now I can hardly get it to boot at all- it just hangs on a bare DOS prompt even. Sometimes I've even had this screen saying the BIOS is damaged come up on a couple of boots! (Sorry for poor quality picture).
Capture.PNG
Are these easy to take apart? Is there a heatsink on the CPU or something that might need new paste? Is there a fan that's failed even? I'm going to leave it for a bit and try again later.

Cheers,
Steve

OK it appears to be a heat problem as I am running it with no issues for 15 mins or so now even doing some benchmarks with it balanced on my air conditioning unit set to 17'C! I'll strip this laptop down then and look for a heatsink that's loose or something.

SteveC wrote on 2021-08-18, 22:26:

SteveC wrote on 2021-08-18, 21:54:

So it turned up today and I checked where you said and there's just a coin cell rechargeable battery with no leakage? 20210818_2 […]
Show full quote

bjwil1991 wrote on 2021-08-17, 02:40:

I have a T2150CDT myself. Remove the wake battery (open the hood, remove the main battery, move the plastic anti-static piece, remove the 4-5 screws, and remove the 7.2V NiMH battery and clean the corrosion off before it's too late.

If you need the drivers and utilities, I'll send a link to all of it.

Oh. Before I forget, a floppy drive from a Satellite Pro 400 Series will work with it as well (tested myself since the original broke on me).

So it turned up today and I checked where you said and there's just a coin cell rechargeable battery with no leakage?
20210818_221955.jpg

The machine worked fine for about 15-20 mins - I got into Windows 95, even played some games, (even the battery worked for about 10 mins!) but I had a few random crashes then tried copying over some files from a CD and it froze and now I can hardly get it to boot at all- it just hangs on a bare DOS prompt even. Sometimes I've even had this screen saying the BIOS is damaged come up on a couple of boots! (Sorry for poor quality picture).
Capture.PNG
Are these easy to take apart? Is there a heatsink on the CPU or something that might need new paste? Is there a fan that's failed even? I'm going to leave it for a bit and try again later.

Cheers,
Steve

OK it appears to be a heat problem as I am running it with no issues for 15 mins or so now even doing some benchmarks with it balanced on my air conditioning unit set to 17'C! I'll strip this laptop down then and look for a heatsink that's loose or something.

The paste is either dried out / separated or the fan is bad. Heatsink could be loose as well but that would normally only happen if somebody took it apart and didn't put it back together properly.

Got this PS/2 to XT keyboard thingy just in case my only XT keyboard goes pop and test other XT class systems.

Happy is me.....😉

Cooler replacement for S370 stock screamer. Also accidentally matches other heatsinks.

Bought this beautiful Resound New Wave MCA from Texelec. One thing I forgot, was that my IBM PS/2 P70 only has half lenght second microchannel slot. The card is an inch too long. About 155€ down the drain, damn it 🙁

CrFr wrote on 2021-08-19, 19:18:

Bought this beautiful Resound New Wave MCA from Texelec. One thing I forgot, was that my IBM PS/2 P70 only has half lenght second microchannel slot. The card is an inch too long. About 155€ down the drain, damn it 🙁

IMGP2109_.jpg

Looks like that fan probably vents directly to the outside of the case. Why not just relocate the fan to the outside of the case?

cyclone3d wrote on 2021-08-19, 19:24:

Looks like that fan probably vents directly to the outside of the case. Why not just relocate the fan to the outside of the case?

There's a metal frame around that fan. And I'm not going to start modifying this mint condition machine.

edit: Another option would be to lose that SCSI-controller and SD-adapter, but after getting used to plentiful storage and ease of transferring files, going back to original 40MB ESDI hard drive is not tempting.

Short scsi cards are also a thing. they look like this: https://www.ebay.com/itm/271232681061?epid=13 … HoAAMXQhpdR0wZR

A Fujitsu Myrica with what I beleive are original parts except for the fdd, cd, HDD and peripheral.

Msi6119 v1.1
P2 @400 MHz
ATI rage pro agp 2x
Aureal vortex

Huh, first time I've seen that model. Love the huge red Fujitsu logo.

Finally got the controller port board for the Diamond Edge 3D thanks to a Vogons user that mentioned these were up for sale. Now all that's missing are the cables to connect the two but those should be much easier to source:

And also, following the principle that you can never have too many Socket 3 and Socket 7 boards I got these two at a local flea market, but haven't tried them yet: